OAS logo
Library Digitization Homepage
OAS Homepage
Volume 59—1979

{Page 70}


K. Ramarajan and K. D. Berlin

Department of Chemistry, Oklahoma State University, Stillwater, Oklahoma

Synthesis and physical and spectral characteristics of 9-methylene-7-oxa-1-thiaspiro[4.5]decan-8-ones are reported. Investigation of the thermodynamic and kinetic parameters for ring reversal in 9-methylene-7-oxa-1-thiaspiro[4.5]decan-8- one-3,3,5,5-d4 by DNMR is described. The barrier height for ring reversal is estimated to be about 7-8.5 kcal/mol.


Introduction Materials Method Results Discussion References Table of Contents Home

Presented herein are the results of a variable temperature study of 9-methylene- 7-oxa-1-thiaspiro[4.5]decan-8-one and derivatives. It is known (1) that many systems containing the alpha-methylene-gamma-butyrolactone unit have potential antitumor activity. This fact and the results of a recent investigation carried out in this laboratory (2) on the dynamic properties of the system 1a~   1b~prompted us to undertake an investigation of the thermodynamic and kinetic characteristics of the heteraspiro-a-methylene-g-butyrolactone system 2a~   2b.~Although ring reversal was known to be rapid in many 1-hetera-4-cyclohexanones (3), the original reasoning for the 2~system supposed the spiro system might have a preferred configuration at C-4 because of the long-range polar influence of the hetero atom.


Introduction Materials Method Results Discussion References Table of Contents Home

The three spirolactones used in this study were: 9-methylene-7-oxa-1-thiaspiro-[4.5]decan-8-one-3,3,5,5-d4 (2a~   2b);~2,2,6,6-tetramethyl-9-methylene-7-oxa-1-thiaspiro[4.5]decan-8-one (9a~   9b);~and 2,6-cis-diphenyl-9-methylene-7-oxa-1-thiaspiro-[4.5]decan-8-one (10a~   10b).~All compounds were synthesized by a Reformatsky type reaction. The appropriate thianone was allowed to react with activated zinc and ethyl a-(bromomethyl)acrylate. Since the usual method of carrying out this reaction, namely, addition of ethyl a-(bromomethyl)acrylate (in THF) to a mixture of zinc and thianone (in THF), resulted in the formation of sulfonium salts, the following modified procedure was adopted. Separate solutions of ethyl a-(bromomethyl)acrylate and the appropriate thianone were first prepared by dissolving 0.01 mole of each reagent in 10 ml of dry THF. Ten ml each of these two solutions were then placed in two separate pressure-equalizing, addition funnels. Twenty-five drops of the solution of ethyl a-(bromomethyl)acrylate were first added to activated zinc (0.011 g-at) in a 3-necked, 100-ml round-bottom flask kept at 45-50 C in an atmosphere of nitrogen. After 3 min, during which time the

{Page 71}

Reformatsky reagent formed, twenty-five drops of the thianone solution were added. This was followed by the addition, after 3 min, of twenty-five drops of the solution of ethyl a-(bromomethyl)acrylate. After these alternate additions were completed (ca. 2 hr), the reaction mixture was kept at 45-50 C for a period of 3 hr. The reaction mixture was then added to ice-cold, 5% sulfuric acid (100 ml). This usually yielded an oily product. Extraction with ether (75 ml), drying the ether extract (anhydrous Na2SO4), and evaporation of the ether (on a rotary evaporator), resulted in the formation of crystalline products which were recrystallized from suitable solvents. The physical and spectral characteristics of the compounds are given in Table 1. Although there is a published procedure (4) for preparing ethyl a-(bromomethyl)acrylate, it was possible to improve the yield of the ester while eliminating a step. Instead of isolating B,B'-dibromoisobutyric acid, as reported by the original workers (4), it was possible to obtain, in one step, the unsaturated acid, a-(bromomethyl)-acrylic acid (3).~The formation of compounds with phenyl groups in the axial positions is deemed untenable from a steric point of view.

{Page 72}


Introduction Materials Method Results Discussion References Table of Contents Home

Consider the ring reversal process in the equilibrium, 2a~   2b.~At temperatures sufficiently below the coalescence temperature, the ring reversal process is slow enough to permit NMR examination of the two conformers separately (5, 6). Since the environments of the H-10 protons differ in the two conformers, the chemical shifts are expected to be different. The areas under the respective peaks should be a measure of the relative concentration of 2a~and  2b~(5). The equilibrium constant can be calculated by:

Keq = the equilibrium constant for the reversal process. Measurement of chemical shift differences between protons of methanol and the use of an empirical equation relating chemical shift differences to temperature (7) permitted the accurate determination of various temperatures at which the spectra were recorded. For temperatures sufficiently above the coalescence temperature, the chemical shift method could be applied to calculate Keq (8). Unfortunately, the chemical shifts for the pure axial and equatorial protons were not obtainable at ambient temperatures in system 2 ;~model compounds that were conformationally biased should be used to obtain specific proton chemical shifts (8). In our case, it was reasoned that 2,6-cis-diphenyl-9-methylene-7-oxa-1-thiaspiro[4.5]decan-8-ones (~10a10b~) could serve as models, by assuming that the phenyl groups were equatorially positioned and would have no appreciable effect on the chemical shift of H-10 protons. However, the Reformatsky reaction of cis-2,6-diphenylthian-4-one gave only one isolable isomer of unknown configuration at C-4. Hence use of the chemical shift method could not be justified to study 2.~


Introduction Materials Method Results Discussion References Table of Contents Home

Cooling the solution of 2,2,6,6-tetramethyl-9-methylene-7-oxa-1-thiaspiro[4.5]-decan-8-one (9a~   9b)~in acetone-d6 to as low as -100 C did not result in separation of the signal from H-10 protons. This implied that the ring reversal was still sufficiently rapid to give only one time-averaged signal for these protons. Since the solution freezes below this temperature, no further experiments were attempted. It was considered that the presence of four methyl groups 9a~   9b~in or would strain the system, and, to relieve the strain, the six-membered ring could flatten. This would have the effect of lowering the energy barrier for ring reversal allowing a fast equilibration even at -100 C. Consequently 9-methylene-7-oxa-1-thiaspiro[4.5]decan-8-one-3,3,5,5-d4 was examined in acetone-d6 but again no splitting of the H-10 proton signals occurred down to -100 C. Hence, a 1:1 mixture of Freon-21 and acetone-d6 was tried as the solvent system. Unfortunately no splitting was observed for H-10 protons even down to -110 C.


Introduction Materials Method Results Discussion References Table of Contents Home

Results of a previous investigation (2) carried out in this laboratory for the system 1~gave the following kinetic parameters; DG* = 10.9 kcal/mol and Tc = -64 C. Comparison of published DG* and Tc values obtained for cyclohexane (8), piperidine (9,10), oxane (11), thiane (11), selenane (12), and tellurane (12,13) show that as a ring carbon was replaced successively by an element of greater electronegativity from the same period of the periodic table, the barrier height to ring reversal decreased. Also replacement of a heteroatom by another heteroatom below it in the same group of the periodic table lowers the barrier height.

Assuming the separation between the axial and equatorial H-10 proton signals at temperatures well below the coalescence temperature to be between 5 to 15 Hz [which seems reasonable from the results of the system 1~(2) ] and using the equation DG* = 4.58 Tc [9.97 + log Tc /Dv ] cal. mol-1 (5), the free energy of activation for 2a~   2b~can be calculated. Results from three different coalescence temperatures are shown in Table 2. The signal due to H-10 protons did begin to broaden

{Page 73}

at -110 C but did not split into two separate signals. It is concluded that Tc is probably not much below -110 C. The calculated DG* values in Table 2 show that Tc is the major contributor to barrier height. In contrast, even a threefold increase in Dv does not change the value of DG* by more than 3% from the average. In summary, we conclude that the DG* value for 2a~   2b~lies somewhere between 7-8.5 kcal/mol. Apparently ring flattening is extensive and preference for either conformer is small.


We gratefully acknowledge partial support by the College of Arts and Sciences, Oklahoma State University, in the form of salary to K. D. Berlin.


Introduction Materials Method Results Discussion References Table of Contents Home

1.   S. M. KUPCHAN, J. E. KELSEY, M. MARUYAMA, J. M. CASSADY, J. C. HEMINGWAY, and J. R. KNOX, J. Org. Chem. 34: 3876-83 (1969).

2.   D. J. O'DONNELL, K. RAMALINGAM, K. D. BERLIN, S. E. EALICK and D. VAN DER HELM, J. Org. Chem. 43: 4259-65 (1978).

3.   J. B. LAMBERT and S. I. FEATHERMAN, Chem. Rev. 75: 611-626 (1975).

4.   A. F. FERRIS, J. Org. Chem. 20: 780-87 (1955).

5.   J. A. POPLE, W. G. SCHNEIDER, and H. J. BERNSTEIN, High Resolution Nuclear Magnetic Resonance, McGraw-Hill Book Company, New York, 1959.

6.   L. M. JACKMAN and F. A. COTTON, Dynamic Nuclear Magnetic Resonance Spectroscopy, Academic Press, New York, 1975.

7.   A. L. VAN GEET, Anal. Chem. 42: 679-80 (1970).

8.   E. L. ELIEL, Chem. Ind. (London): 568 (1959).

9.   J. B. LAMBERT and R. G. KESKE, J. Am. Chem. Soc. 88: 620-22 (1966).

10.   J. B. LAMBERT, R. G. KESKE, R. E. CARHART, and A. P. JOVANOVICH, J. Am. Chem. Soc. 89: 3761-7 (1967).

11.   J. B. LAMBERT, R. G. KESKE, and D. K. WEARY, J. Am. Chem. Soc. 89: 5921-4 (1967).

12.   J. B. LAMBERT, C. E. MIXAN, and D. H. JOHNSON, J. Am. Chem. Soc. 95: 4634-9 (1973).

13.   J. B. LAMBERT, C. E. MIXAN, and D. H. JOHNSON, Tetrahedron Lett. 4335-8 (1972).